The Electric Oscillating Tool is a widely applicable tool capable of processing many different materials that the drag knife is unable to process.

The EOT is ideally suited for cutting softer, multilayered materials. The high oscillating frequency of the EOT makes it possibile to cut at high processing speeds for superior throughput.

Depending on the application, the EOT is available with a .5mm or 1mm stroke. For materials up to a thickness of 3mm, Zünd recommends using the EOT with 0.5mm stroke; thicker materials require the EOT with 1mm stroke.

To accommodate different substrates and levels of detail in contour cuts, Zünd offers a range of flat and pointed EOT blades. Flat-tipped blades tend to be better suited for medium-density or fibrous materials and for relatively simple contour cuts with large radii. The wide cutting edge allows for high processing speeds.

Pointed blades are best for fine detail and tight curves. For processing thicker, tougher materials, Zünd recommends using the POT (Pneumatic Oszillating Tool).

Advantages at a glance

• Depending on application, available with 0.5 mm or 1.0 mm stroke
• Perfect for cutting detailed contours
• Very high stroke frequency
• High cutting speeds
• Compatible with G3, S3, L3